Apart from the relatively crude moulding the LiP13 kit from PM suffers from a pretty shitty canopy.

Firstly it does not fit very well which I have been slowly addressing and secondly the mould attachment points are overlarge and impinge into the canopy area.

I had tried to fix this with a fun afternoon of sanding the canopy with toothpaste but due to the cheap brittle plastic they used this resulted in some stress lines in the glass and very little visible difference in the obvious attachment points.

So somewhat inevitably the only solution left is to vacform a new canopy. I have done this before but not for many years and of course in the post Xmas clean up I have of course thrown out the couple of sheets I was keeping just in case.

The white blob at the front left is the canopy filled with Milliput !